Steve_G 51 Posted February 1, 2014 I picked this up recently to use for steel matches. It was a nice little gun but, needed some improving. VQ accurizing kit, VQ bolt tune up kit, VZ grips, Burris Fastfire III, MaddMacs compensator. Before After Quote Share this post Link to post Share on other sites
T Bill 649 Posted February 1, 2014 There you go ready to rock n' roll. Good luck with it, you will like it I'm sure. TANDEMKROSS makes a bushing to get rid of the Magazine Disconnect if you would like to do that mod as well as a replacement blank to get rid of the loaded chamber indicator. Quote Share this post Link to post Share on other sites
Steve_G 51 Posted February 1, 2014 Haha, I forgot to mention those. They are done as well. Quote Share this post Link to post Share on other sites
FLHX 1 Posted February 7, 2014 I just got the same pistol and I am looking to do the same internal mods. I have found the accu kit but it seems that everything doesn't come in one kit so I was looking to buy everything from one place. Did you get your parts from one place and if so which one? I have been looking at eabco.com rimfiresports.com and a few others but none of them have all I want so if you have another place to look let me know. I am looking for the Volq accu kit with the mag disconnect. The Volq kit says not to use any other bushing with there kit. What bushing did you use? It seems as though the kit doesn't come with the bushing. Quote Share this post Link to post Share on other sites
Heavyopp 167 Posted February 7, 2014 Nice -- Now I know where I can try one I have to go put in for permits... Quote Share this post Link to post Share on other sites
Steve_G 51 Posted February 7, 2014 I just got the same pistol and I am looking to do the same internal mods. I have found the accu kit but it seems that everything doesn't come in one kit so I was looking to buy everything from one place. Did you get your parts from one place and if so which one? I have been looking at eabco.com rimfiresports.com and a few others but none of them have all I want so if you have another place to look let me know. I am looking for the Volq accu kit with the mag disconnect. The Volq kit says not to use any other bushing with there kit. What bushing did you use? It seems as though the kit doesn't come with the bushing. I used the BAM bushing but had to use the factory hammer. You can get everything you are looking for direct from Voquartsen. Quote Share this post Link to post Share on other sites
Targetpractice 3 Posted February 17, 2014 nice! looks good! do these shoot all kinds of ammo including bulk? or are they picky Quote Share this post Link to post Share on other sites
alec.mc 180 Posted February 17, 2014 Now only if it didn't take him 3 minutes to find the dot Quote Share this post Link to post Share on other sites
Steve_G 51 Posted February 17, 2014 nice! looks good! do these shoot all kinds of ammo including bulk? or are they picky I have only run Federal bulk through it since that's all I have. Now only if it didn't take him 3 minutes to find the dot I'm ditchin the dot. Getting a fiber front so it only takes me 2 minutes to find the front sight. Quote Share this post Link to post Share on other sites