Tallday 10 Posted February 22, 2015 I should be getting in my new Kimber Advanced tactical 8400 in soon. I also picked up an SWFA ss10x42mm scope with TPS scope mounts! I am running out of cash for this project and was wondering if anyone had a 30mm lapping kit and torque wrench to put it all together properly! I still need to buy match dies and reloading supply's so rather not spend 100.00 on a scope mounting kit i would only be using one or two times. or a good smith who can do this for me properly without charging the price of the kit. Quote Share this post Link to post Share on other sites
Pizza Bob 1,488 Posted February 22, 2015 TPS rngs do not need to be lapped. They are concentric to .0002" Quote Share this post Link to post Share on other sites
Iggyort 44 Posted February 22, 2015 Same with Badger Ordnance and Nightforce Rings Quote Share this post Link to post Share on other sites
Tallday 10 Posted February 22, 2015 nice to know! I would probably do it for my own neurotic self... Quote Share this post Link to post Share on other sites
Pizza Bob 1,488 Posted February 22, 2015 nice to know! I would probably do it for my own neurotic self... Chances are that you'd do more harm than good. With TPS rings you can tighten down one side completely and then the other and get no scope rotation. Quote Share this post Link to post Share on other sites
Tallday 10 Posted February 22, 2015 Wow! Thanks Bob good to know Quote Share this post Link to post Share on other sites